DHC Systems Guide

DHC Systems Guide

Did You Know?

Add 1 Location under PVA opens the Facility add page with Patient Surveys and Discharge Checks already switched on. One form adds the room, gives it a uCode and sets where its PVA questions come from. The full walkthrough of that page is in the Facility article “Adding a Single Location or Employee”. This article covers the PVA specific part.

Watch: adding one location with PVA switched on (1:44)
The Add a Location page: zone 3rd Floor East and location name Room 318 on the left, Patient Surveys and Discharge Checks switched on with Use a template and Patient Visit Standard selected on the right, and the phone preview showing the PVA button
Adding a room with PVA on and a template chosen

How to add a room

  1. In the sidebar click PVA, then Add 1 Location.
  2. Pick the Zone, or choose + New zone… and type a new one.
  3. Type the Location name, for example Room 318. If a similar room already exists the page tells you while you type.
  4. On the right, Patient Surveys and Discharge Checks is already switched on. Under Where should its questions come from? pick one:
    • Use a template, then choose the Scan Template. This is the recommended choice.
    • Copy from another location, then pick a room whose own questions you want copied.
    • Leave blank for now. The uCode will say “not ready” for PVA until questions are added.
  5. The PVA block on the add page with the three choices Use a template, Copy from another location and Leave blank for now, and Patient Visit Standard selected
    The three ways to give the new room its questions
  6. Switch on any other products this room should have, such as MRC Task List.
  7. Check the What the worker will see preview, then click Save location.

You land on the room’s uCode record page. From there you can print the uCode, or go back to Locations where the new room shows the template name in the Questions from column.

Who can do this

M1 accounts and Directors (M2).

Tips

  • The room’s Type in the Locations list shows unassigned for rooms added this way. That does not affect scanning or reports.
  • Adding several rooms at once? Use Bulk Add Locations instead.
Share This Article

Leave a Comment