The Dashboard is the first page you see after signing in. It shows one Snapshot tile for each product your company uses, so in a few seconds you know whether today’s work is happening and how it is going. The tiles load straight from the database, so the page is quick, even on a phone.

Each tile covers one day in your company’s local time. It shows today if anything has been recorded today. If not, it falls back to yesterday and the header says Latest activity instead of Today. If there was nothing on either day you see Today with zeros and the charts say “No activity recorded for this day”. The header also has an Open report link that takes you to that product’s full report pages.


The upper chart counts how many scans, checks or surveys were completed in each hour of the day, from 12a to 11p. The lower chart breaks the answers inside those scans into their outcomes for each hour. Hover over any hour on a computer to see the exact numbers. The highest point is labelled.
In the lower chart green is Sat (or Yes), red with a dashed line is Unsat (or No), and purple dotted is NA. The hour used is when the scan was finished for MRC, eQA and HWM, and when the survey was started for PV and DR.

The coloured boxes are the totals for the day shown. Teal boxes are counts, green is good, red needs attention.
The half circle is the Sat Ratio (Sat divided by Sat plus Unsat) or the Yes Ratio (Yes divided by Yes plus No). NA answers are left out. The small black tick is the 90% target. On the PVA Patient Visit and HWM tiles the arc turns green at 90% or above, amber from 70%, and red below that. The other tiles keep one colour. With no answers yet the gauge reads 0.00%.

Tiles stack in one column. The charts come first, then the stat tiles in a row, then the gauge. Scroll down for the next product. Pull to refresh to update the numbers.

The Dashboard is a snapshot, not a report. For filtering, history and detail open the product group in the sidebar and use its report pages: Dashboard (S) for everyone, Dashboard (M) and Daily for M1 accounts and Directors (M2). Each product’s section of this guide explains its reports. The Open report link on a tile takes you to the same place.
Announcements from DHC Systems also show up on the Dashboard when you have something unread. See the article Messages.
Everyone. IC accounts, M1 accounts and Directors (M2) see the same tiles for the products their company uses, always for their own company only.